Vine lattice
This is a lattice or scaffold for climbing plants. It has two support spikes to fix it to the ground. Size of each part can be adjusted depending on the plant size.
Files
vine_lattice.scad: Source code file for OpenSCAD.
vine_lattice.stl: STL with default parameters.
vine_lattice_ai3m.curaprofile: Cura profile used for printing on a Anycubic i3 Mega.
vine_lattice.jpg: End result with default parameters.
Notes
Current version is a single piece, so total size is severely limited by the build volume of the 3D printer. The default provided STL is about the maximum vertical size that can be printed with a Anycubic i3 Mega.
Cura profile is not well optimized. It is just default medium profile plus a small brim. I had some adhesion problems on the first layer, but the end result was decent anyway.
Next version might have spikes rotated to one side to avoid large vertical steps on low resolution prints.
Last updated